This 7.6 gm motor is the largest motor we offer. They feature a 6mm stack. This is a power house and can put out amazing thrust. Even if this motor is optimized for 3 cell operation you can use it with 1 or 2 cells as well if max thrust is not needed. These motors are perfect for 3D planes weighing between 60-100gms, and sports aerobatic planes up to around 150gms. Lipoly cells like the Kokam 340SHD's, or WES310s are a good match for the motor.

The appropriate propeller for this motor are the GWS 6030 or 7035.
 

Technical data

62,90 €/ pcs.

The 5.8 gm Gold line motor feature a 4mm stack and has been specifically designed keeping 3D flying in mind. This motor is perfect for a micro 3D plane weighing less than 60g. They are very versatile motors and can run from 2S or 3S Lipoly packs depending on the application.

The appropriate propeller for this motor are the GWS 5030 or 6030.

Technical data

59,50 €/ pcs.

Stator diameter:                          13mm
shaft diameter:                           1,5mm
supply voltage: 3 - 12V (1-3 Lipo cells)

 The bell and shaft assembly come out entirely when pulled. The magnetic field strength is enough to prevent the bell from coming out during normal puller mode use.
Another advantage with these motors is that the prop can be pressed on the shaft easily by removing the bell/shaft assembly and then just slipping it back in.
Along with our motors, we also offer easy to use collet type prop adapters and motor mounts.

We strongly recommend to operate all the Gold line brushless outrunner motors with the most lightweight  4Amp. brushless motor controller YGE4-BL.

This is the smallest micro brushless outrunner commercially available, providing extraordinary power at a maximum current of less than 2 Amps. This powerful motor can be operated with 1, 2 or 3 Lipo cells (e.g. Kok145).  The LRK 10-3-32Y has been developed for direct drive of smallest airplane models up to about 60g airborne mass.

The appropriate propeller for this motor is the GWS 3020 - its 1.5mm bore is good for press-fit to the motor shaft. Using this prop the maximum static thrust is 50g!!
We recommend to operate the LRK 10-3-32Y with the most
lightweight  4Amp. brushless motor controller YGE4-BL.

Technical data

max thrust:  up to 50g
mass:       3,3 g

55 €/ pcs.